CHAPTER 3: Replacing notebook components
92
10 Remove the screws on the top that secure the LCD panel hinge to the chassis.
11 Lift the LCD panel assembly up and away from the notebook.
12 Place the new LCD panel assembly onto the notebook, then replace the hinge screws
removed in Step 10.
13 Slide the antenna cables through the retaining clips, under the system board, then
into the wireless bay.
14 Lay the LCD cable along the flat area under the keyboard, then plug it into the
notebook. Run your finger along the cable to re-stick the cable to the notebook.
15 Replace any tape that held the antenna wires.
16 Close the LCD panel, turn the notebook over so the bottom is facing up, then replace
the bottom hinge screws removed in Step 5.
17 Replace the keyboard by following the steps in “Replacing the keyboard” on
page 78.
18 Replace the keyboard cover by following the steps in “Replacing the keyboard
cover” on page 75.
19 Turn the notebook over so the bottom is facing up.
20 Reconnect the antenna wires to the wireless card by following the steps in
“Replacing the IEEE 802.11 wireless card” on page 65.