Filter
Top Products
GFK-1541B Chapter 2 Installation 2-35
2
Also, in this case, set the subnet mask, and gateway IP address to 0.0.0.0.
Note
If the isolated network is ever connected to another network, the IP addresses
10.0.0.1 through 10.0.0.255 must not be used and the subnet mask,and
gateway IP address must be assigned by the network administrator. The IP
addresses must be assigned so that they are compatible with the connected
network. Refer to Chapter 6, “Network Administration Support”, for more
information on addressing.
See also “Determining If an IP Address Has Already Been Used”.
Network Time Sync
:
Selection of the method used to synchronize the real-time clocks over the
network. Currently the choices are None/DISABLED (for no network time synchronization) and
SNTP/ENABLED (for synchronization to remote SNTP servers on the network).
Serial Port Parameters
These parameters are for the RS-232, RJ-11 serial port on the Ethernet Interface. This port is
used for the Station Manager connection.
Data Rate (bps):
Data rate (bits per second) for the port. Choices are 1200, 2400, 4800, 9600,
or 19200.
Parity:
Type of parity to be used for the port. Choices are None‡, Even, or Odd*.
Flow Control:
Type of flow control to be used for the port. Choices are Hardware, Software, or
None. The Software selection has no effect.