Filter
Top Products
Messages E–3
File name 32sii-Manual-E-0424
Printed Date : 2003/4/24 Size : 17.7 x 25.2 cm
% !!
Attempted to refer to a nonexistent program label (or
line number) with
U
,
U
,
W
, or {
}.
Note that the error
% !!
can mean
you explicitly (from the keyboard) called a
program label that does not exist; or
the program that you called referred to another
label, which does not exist.
The catalog of programs (
z
X
{
} )
indicates no program labels stored.
!
SOLVE cannot find the root of the equation using the
current initial guesses (see page C–8). A SOLVE
operation executed in a program does not produce
this error; the same condition causes it instead to skip
the next program line (the line following the
instruction
#
variable).
#$
Warning (displayed momentarily); the magnitude of
a result is too large for the calculator to handle. The
calculator returns ±9.99999999999E499 in the
current display format. (See "Range of Numbers and
Overflow" on page 1–12.) This condition sets flag 6.
If flag 5 is set, overflow has the added effect of
halting a running program and leaving the message
in the display until you press a key.
!
Indicates the "top" of program memory. The memory
scheme is circular, so
!
is also the "line"
after the last line in program memory.
"
The calculator is running a program (other than a
SOLVE or
∫
FN routine).
!
Attempted to execute
#
variable or
∫
d
variable without a selected program label. This can
happen only the first time that you use SOLVE or
∫
FN
after the message
&
, or it can happen
if the current label no longer exists.
#
!#
A running program attempted to select a program
label (
/
label) while a SOLVE operation was
running.
#1 #2
A running program attempted to solve a program
while a SOLVE operation was running.
#1
∫
2
A running program attempted to integrate a program