Filter
Top Products
136 Printer Interfaces EN
9 If you keep BOOTP=YES *, the values for the TCP/IP parameters
will be provided by the BOOTP file, RARP, or DHCP and no other
TCP/IP configuration is necessary. Skip to step 17.
– OR –
Press V
ALUE to change the value of the BOOTP= parameter.
BOOTP=NO displays.
10 Press S
ELECT to save the selection. BOOTP=NO * appears, and
you are prompted to configure each of the TCP/IP parameters.
11 Press I
TEM to continue configuring. IP BYTE 1=<value>> *
displays.
12 Press V
ALUE until the value of the first byte of the IP address
displays.
13 Press S
ELECT to save the value.
14 Repeat steps 12 and 13 to configure the remaining bytes of the IP
address.
15 Press I
TEM to continue.
16 Repeat steps 12-15 to configure the subnet mask bytes (
SM),
default gateway (
GW), and timeout (TIMEOUT).
17 If you are finished, press G
O to return the printer to the READY
state.
– OR –
See the appropriate sections for other protocols that will be used.