Filter
Top Products
TM 11-6625-2958-14&P
SECTION O
INTRODUCTION
.
0-1. SCOPE.
a. This manual describes DC Power
Supply PP-7545/U (fig. l-l) and
provides maintenance instructions.
Throughout this manual, PP-7545/U
is referred to as the Hewlett-Pack-
ard (HP) Model 6269B DC Power
supply.
0-2. INDEXES OF PUBLICATIONS.
a. DA Pam 310-4. Refer to the latest issue of
DA Pam 310-4 to determine whether there are new
editions, changes, additional publications per-
taining to the equipment.
b. DA Pam 310-7: Refer to DA Pam 310-7 to
determine whether there are modification work
orders (MWO’s) pertaining to the equipment.
0-3. FORMS AND RECORDS.
a. Reports of Maintenance and Unsatisfactory
Equipment. Maintenance forms, records, and
reports which are to be used by maintenance per-
sonnel at all maintenance levels are listed in and
pre
SCribed by TM 38-750.
b. Report of Packaging and Handling Deficien-
ties. FiII out and forward DD Form 6 (Packaging
Improvement Report) as prescribed in AR 735-11
-2/NAVUPINST4440.127E/AFR 400-54/MCO
4430.3E
and DSAR 4140.55.
c. Discrepancy in Shipment Report (DISREP)
(SF 361). Fill out and forward Discrepancy in
Shipment Report (DISREP) (SF 361) as prescribed
in AR 55-38/NAVSUPlNST 4610.33B/AFR 75-
18\MCO P4610.19C and DLAR 4500.15.
0-4. REPORTING EQUIPMENT
IMPROVEMENT
RECOMMENDATIONS (EIR).
EIR’s will be prepared using SF 368 (Quality Defi-
ciency Report). Instructions for preparing EIR’s
are provided in TM 38-750, the Army Mainten-
ance Management System. El R’s should be mailed
direct to Commander, US Army Communication
and Electronics Materiel Readiness Command,
ATTN: DRSEL-ME-MQ, Fort Monmouth, NJ
07703. A reply will be furnished direct to you.
0-5. ADMINISTRATIVE STORAGE.
Administrative storage of equipment issued to and
used by Army activities shall be in accordance with
TM 740-90-1 and paragraph 2-8.
0-6. DESTRUCTION OF ARMY
ELECTRONICS MATERIEL.
Destruction of Army electronics materiel to pre-
vent enemy use shall be in accordance with TM
750-244-2.
SAFETY PRECAUTIONS.
A periodic review of safety precautions in TB 385-4 is
recommended.
When the equipment is operated with covers
removed while performing maintenance, DO NOT TOUCH ex-
posed connections or compments. MAKE CERTAIN you are
not grounded when making connections or adjusting com-
ponents inside the power supply.
WARNING
HIGH VOLTAGE is used during the “performance
of maintenance as instructed in this manual.
DEATH ON CONTACT may result if personnel
fail to observe safety precautions.
0-1