Filter
Top Products
10
Figures
Figure 2-11. Connecting the Bottom Section to the Personal Workstation
65
Figure 2-12. Closing the Bottom Section . . . . . . . . . . . . . . . . . . . . . . . . 65
Figure 2-13. View of the Top Sections Hinge Slots. . . . . . . . . . . . . . . . . 66
Figure 2-14. Connecting the Top Section to the Personal Workstation. 67
Figure 2-15. Closing the Top Section. . . . . . . . . . . . . . . . . . . . . . . . . . . . 67
Figure 2-16. Inside View of the Left-Side Panel. . . . . . . . . . . . . . . . . . . 68
Figure 2-17. Replacing the Left-Side Panel . . . . . . . . . . . . . . . . . . . . . . 69
Figure 2-18. Left-Side Panel Showing the Half-Inch Gap . . . . . . . . . . . 69
Figure 2-19. Sliding the Left-Side Panel into Place . . . . . . . . . . . . . . . . 70
Figure 2-20. Replacing the Left-Side Panel Thumb Screws . . . . . . . . . 70
Figure 2-21. Personal Workstation Memory Slots . . . . . . . . . . . . . . . . . 71
Figure 2-22. Preparing the Memory Slot Ejector Tabs . . . . . . . . . . . . . 73
Figure 2-23. Installed DIMM Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
Figure 2-24. Keyed DIMM Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
Figure 2-25. Pressing Downward on the Memory Slot Ejector Tabs. . . 75
Figure 2-26. Lifting the DIMM Card Out of the Personal Workstation 76
Figure 2-27. IDE Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77
Figure 2-28. FDD Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78
Figure 2-29. System Board Connectors for the IDE and FDD Cables . 78
Figure 2-30. Removing the Front Panel CD Drive Blank . . . . . . . . . . . 80
Figure 2-31. Removing the Metal Blank from the Accessory Chassis. . 81
Figure 2-32. Attaching the Guide Rail to the CD Drive. . . . . . . . . . . . . 82
Figure 2-33. Properly Installed Guide Rail. . . . . . . . . . . . . . . . . . . . . . . 82