Filter
Top Products
116 Chapter2
Opening Your Personal Workstation and Installing Accessories
Installing and Removing Accessory Boards
3. Remove the I/O card from the I/O connector on the system board.
Note that you should lift upward on the I/O card’s bulkhead and its
opposite edge. See Figure 2-79.
Figure 2-79 Removing the I/O Card
4. Place your I/O card in its anti-static bag making sure you are wearing
the static-grounding strap that was shipped with your I/O card.
5. Replace the bulkhead blank as shown in Figure 2-80.
Figure 2-80 Replacing the Bulkhead Blank
Bulkhead
T-15 Torx
Screw