Filter
Top Products
Chapter 3 141
Troubleshooting Your Personal Workstation
If Your Personal Workstation Does Not Start Properly
c. Turn on the Personal Workstation. This will erase the CMOS
memory.
d. Wait until the Personal Workstation has started. A message will
be displayed similar to this: “Configuration has been cleared, set
switch Clear CMOS to the open position before rebooting.”
e. Turn off the Personal Workstation, disconnect the power cable,
and remove the cover.
f. Set the system board switch 6 (CLEAR CMOS) UP to retain the
configuration.
2. Replace the cover, and reconnect the power and cables.
3. Switch on the Personal Workstation. An error message will be
displayed similar to the following:
The Personal Workstation will stop. Press Enter (to view the system
errors) and then press Esc.
4. Run Setup by pressing F2. CMOS default values will be
automatically downloaded and saved.
5. Make any other changes you want and press Esc to save the
configuration and exit from Setup.
On your monitor: On your Personal
Workstation’s LCD:
Incorrect PC Configuration Error! POST Error xx