Filter
Top Products
72 Chapter2
Opening Your Personal Workstation and Installing Accessories
Installing and Removing Memory
Installing Additional Memory
Perform the following steps to add memory (DIMM cards) to your
Personal Workstation.
WARNING Turn the Personal Workstation off and unplug the power cord
before installing or removing memory.
1. Open the left-side panel of your Personal Workstation as explained in
the section “Removing the Left-Side Panel” in this chapter.
2. Position the memory slots as show in Figure 2-21. The memory slots
are divided into two banks. Bank A consists of slots 1A through 4A (or
1A through 2A, if it is a P-Class) and Bank B consists of slots 1B
through 4B (2B for P-Class). Note that the memory must be loaded in
matching pairs (banks are interleaved) for example, if you load a card
in slot 1A, you must also load a card in slot 1B of equal size.