Filter
Top Products
138 Chapter3
Troubleshooting Your Personal Workstation
If Your Personal Workstation Does Not Start Properly
Check Internal Items
If the Personal Workstation still does not start properly, follow this
procedure to check the internal items:
1. Turn off the display, the computer, and all external devices.
2. Unplug all power cords and cables, noting their positions. Disconnect
the Personal Workstation from any telecommunications network.
3. Remove the cover.
4. Check the following items:
Table 3-1 Actions to Take and Where to Find Help
Action Reference
Check all internal cables. Ensure they are correctly attached and firmly in
place.
Check that the processor and
VRM are correctly installed.
Refer to the sections “Installing and Removing a
Processor” and “Installing and Removing a
Voltage Regulator Module” in the chapter
“Opening Your Personal Workstation and
Installing Accessories.”
Check that the processor speed
switches have been set correctly.
Call your local HP Support Representative.
Reset the Personal Workstation
or power-off the LAN.
Refer to the section “Your Personal
Workstation’s Hardware Control Panel” in the
chapter “Using Your Personal Workstation.”
Check that the memory modules
are correctly installed.
Refer to the section “Installing Additional
Memory” in the chapter “Opening Your
Personal Workstation and Installing
Accessories.”
Check that accessory boards are
firmly seated in their slots.
Refer to in the section “Installing and Removing
Accessory Boards” in the chapter “Opening
Your Personal Workstation and Installing
Accessories.”
Verify that any switches and
jumpers on the accessory boards
are properly set.
Refer to the manuals that came with each board.