Filter
Top Products
106
Changing Your Workstation’s Hardware Configuration
This appendix describes the procedures to change your workstation’s hard-
ware configuration. It presents the information in the following sections:
• Checking the SCSI IDs
• Preparing your workstation
• Removing the main tray assembly
• Replacing the main tray assembly
• Installing storage devices
• Installing additional memory
• Installing cache boards
• Installing an EISA, GSC, or PCI option board
• Installing an optional System Graphics RAM (EGRAM) board
• Changing your monitor type
CAUTION: Always wear a properly grounded wrist strap when reconfiguring your
workstation.
Use the following tools to remove or replace hardware parts when changing
your configuration:
• Light-duty flat blade screwdriver with 150 mm (6 in.) blade
• Needlenose pliers
• Torx screwdriver
Also, read the ESD Precautions in Appendix A of this guide.