Filter
Top Products
125
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
3 Connect the floppy data cable to the floppy drive and the system board as shown
in, Figure 32.
When connecting the floppy data cable, use the following procedure, as shown
in Figure 32:
a Lift the locking ring on the connector to the up, or unlocked position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
Figure 32 Connecting the Floppy Drive Data Cable
4 Proceed to the section entitled Replacing the Storage Tray Cover on page 132.