Filter
Top Products
166
Changing Your Workstation’s Hardware Configuration
Installing the Optional Fast Wide Differential SCSI Controller
6 Connect the end of FWD SCSI cable to the FWD SCSI controller making sure
that the red line on the cable is toward the rear (away from the fans) of the main
tray, as shown in Figure 67.
Figure 67 Installing the FWD SCSI Cable
7 Set the ferrite bead into the slot on the side of the storage tray. Make sure that the
cable is dressed so that it will not be damaged by the storage tray cover
8 Use the two hex standoffs to install the external connector on the end of the FWD
SCSI cable into the rear panel of the storage tray, as shown in Figure 67.
9 Secure the cable in the cable clip so that it does not interfere with the disk drives,
as shown in Figure 67.
Ferrite Bead
Cable Clip
To FWD SCSI Controller
Red Line
External Connector