Filter
Top Products
Wrong paper width
Cause: The print setting chosen for the print job does not match the paper loaded
in the HP All-in-One.
Solution: Change the print setting or load the appropriate paper in the input tray.
For more information, see:
“
Information on paper” on page 147
“
Change the print settings for the current job” on page 76
“
Load paper” on page 64
Power and connection messages
The following is a list of power- and connection-related error messages:
•
Communication test failed
•
HP All-in-One not found
•
Improper shutdown
•
Two-way communication lost
Communication test failed
Cause: The HP All-in-One is turned off.
Solution: Look at the display on the HP All-in-One. If the display is blank and the
On button is not lit, the HP All-in-One is turned off. Make sure the power cord is firmly
connected to the HP All-in-One and plugged into a power outlet. Press the On button
to turn on the HP All-in-One.
Cause: The HP All-in-One is not connected to the computer.
Solution: If the HP All-in-One is not properly connected to the computer,
communication errors can occur. Make sure the USB cable is securely connected to
the HP All-in-One and the computer, as shown below.
For more information, see:
“
Communication problems over a USB connection” on page 145
Errors 201
Troubleshooting