Filter
Top Products
Removal and replacement procedures 60
Memory
The system has six DIMM slots that support both unbuffered and registered DIMM (UDIMM and
RDIMM) with ECC support. The DIMM slots are divided into two channels of three DIMM slots each.
Memory installation guidelines
Observe the following important guidelines when installing memory modules:
• Use only the following HP approved DIMM types:
○ 1 GB, 2 GB, or 4 GB PC3-10600E UDIMM
○ 2 GB PC3-10600R RDIMM
○ 4 GB PC3-10600R RDIMM
• Populate the DIMM slots in the following sequence:
○ DIMM3A and DIMM6B
○ DIMM2C and DIMM5D
○ DIMM1E and DIMM4F
• Installation of DIMMs with varying speed is not supported.
• Mixing UDIMM and RDIMM is not supported.
• Non-ECC DIMMs are not supported.
CAUTION: DIMMs can be damaged by improper handling. Always use an anti-static wrist strap and
grounding mat, and discharge static electricity before touching DIMMs.
NOTE: To allow an interleaving memory configuration, the Memory Interleaving field in the
Advanced | Advanced Chipset Control menu of the BIOS Setup must be set to Enabled.