Filter
Top Products
Removal and replacement procedures 82
9. Connect the PSU cables.
IMPORTANT: Check the PSU cable label (marked on the cable connector) before connecting
them. See page 37 for information on proper PSU cable connections.
a. Connect the 24-pin and the 4-pin power extension cables to the PSU ATX power cables (1)
b. Route the ATX power cables between the air baffle and the power supply (2).
c. Connect the P1 and P2 ATX power cables to their system board connectors (3).
d. Route the drive power cables through the chassis opening opposite the PSU fan.
Connect the P5 power cable to the SATA ODD cable (4).
e. If you are using hot-plug hard drives, connect the P7 power cable to the hot-plug backplane
board (shown in below figure, 5).
If you are using non-hot-plug hard drives, connect the individual power cables (P5–P8) to the
installed hard drives.
10. Perform the post-installation procedure.