Filter
Top Products
4-14
Configuring the Switch From the Console
Configurable Features
Configuring the Switch From
the Console
Trap Receivers
This screen enables you to configure up to ten IP and/or IPX management
stations (trap receivers) to receive SNMP trap packets sent from the switch.
Trap packets describe specific event types. (These events are the same as the
log messages displayed in the event log.) The protocol, address, and commu-
nity define which management stations receive the traps. Check the event log
to help determine why the authentication trap was sent. (Refer to chapter 3
for information on the event log.)
Figure 4-9. The Trap Receivers Configuration Screen (Default Values)
YUMAMOD.BK : 4_ymcnfg.fm5 Page 14 Thursday, February 20, 1997 12:54 PM