Filter
Top Products
B-1
Modem Configuration
B
Modem Configuration
Before installing the modems (one attached to the Switch Management
Module’s console port and one attached at the user end to the terminal/PC),
configure them by this procedure:
1. Connect them, one at a time, to the PC or terminal and issue the appro-
priate AT command, as described in the tables in this appendix.
Note that, in each case, the configuration string for the modem attached
to the switch is different than for the one attached to the PC or terminal.
2. Install the modems in the appropriate locations. Make sure the correct
modem is installed in each location, according to how it was configured.
The modems listed in this appendix have been tested and found to work
properly with the Switch Management Module using the initialization strings
shown.
Hayes Smartmodem Optima 28.8 (V.34)
Hayes Acura 288 V.34 + FAX
At the switch
end:
Issue the following AT command:
AT&FQ2&C2&D3S0=1&W0
At the user end: Issue the following AT command:
AT&FW1&C1&W
At the switch
end:
Issue the following AT command:
AT&FQ2&C2&D3S0=1&W0
At the user end: Issue the following AT command:
AT&FW1&C1&W
YUMAMOD.BK : b_ymmodm.fm5 Page 1 Thursday, February 20, 1997 12:54 PM