Filter
Top Products
4-16
Configuring the Switch From the Console
Configurable Features
Configuring the Switch From
the Console
Console Configuration
This screen lets you enable or disable inbound Telnet access and control the
types of events displayed in the event log. Also specifies the terminal type and
the console screen refresh interval used by the statistics screens (that is, the
frequency with which statistics are updated on the statistics screens).
Note “Inbound” Telnet is Telnet access to the switch console from another device.
“Outbound” Telnet, which is using Telnet through the switch console to access
another device, is always enabled as long as the Switch Management Module
has been configured with a valid IP address. (To configure an IP address for
the switch, refer to “Internet (IP) Service Features” on page 4-8.)
The Switch Management Module supports one inbound and one outbound
Telnet sessions simultaneously.
Figure 4-11. The Console Configuration Screen (Default Values)
default inbound
Telnet setting
YUMAMOD.BK : 4_ymcnfg.fm5 Page 16 Thursday, February 20, 1997 12:54 PM