Filter
Top Products
Removal and replacement procedures 31
2.
After performing the installation or maintenance procedure, slide the server into the rack by pressing
the server rail-release latches.
Power down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1.
Shut down the OS as directed by the OS documentation.
2.
Press the Power On/Standby button to place the server in standby mode. When the server enters
standby power mode, the system power LED changes to amber.
3.
Disconnect the power cords.
The system is now without power.
Remove the server from the rack
To remove the server from an HP, telco, or third-party rack:
1.
Power down the server (on page 31).
2.
Disconnect the cabling.