Filter
Top Products
Removal and replacement procedures 46
To replace the component, reverse the removal procedure.
Center wall
To remove the component:
1.
Power down the server (on page 31).
2.
Extend or remove the server from the rack ("Extend the server from the rack" on page 30, "Remove
the server from the rack" on page 31).
3.
Remove the access panel. ("Access panel" on page 33)
4.
Remove the processor air baffle ("Processor air baffle" on page 45).
5.
Remove the full-length expansion boards ("Expansion board" on page 43).
6.
Lift the center wall retaining latch.
7.
Remove the center wall.
To replace the component, reverse the removal procedure.
Media blanks
To remove the component:
1.
Power down the server (on page 31).
2.
Open or remove the tower bezel ("Front bezel" on page 32).
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.