Filter
Top Products
Removal and replacement procedures 63
5.
Remove the battery pack.
To replace the component, reverse the removal procedure.
System board
IMPORTANT: If replacing the system board or clearing NVRAM, you must re-enter the server
serial number through RBSU.
To remove the component:
1.
Power down the server (on page 31).
2.
Do one of the following:
o
Unlock and remove the bezel ("Front bezel" on page 32).
o
Extend the server from the rack (on page 30).
3.
Remove the access panel ("Access panel" on page 33).
4.
Remove all expansion boards ("Expansion board" on page 43).
5.
Remove the processor air baffle ("Processor air baffle" on page 45).
6.
Remove the center wall ("Center wall" on page 46).
7.
Remove the memory board ("Memory board" on page 50).
8.
Remove the PPM ("PPM" on page 58).
9.
Disconnect all cables attached to the system board.
10.
Remove the heatsink ("Heatsink" on page 56).