Filter
Top Products
Removal and replacement procedures 62
BBWC battery pack
CAUTION: To prevent a server malfunction or damage to the equipment, do not add or
remove the battery pack while an array capacity expansion, RAID level migration, or stripe
size migration is in progress.
CAUTION: After the server is powered down, wait 15 seconds and then check the amber LED
before unplugging the cable from the cache module. If the amber LED blinks after 15 seconds,
do not remove the cable from the cache module. The cache module is backing up data, and
data is lost if the cable is detached.
To remove the component:
1.
Power down the server (on page 31).
2.
Do one of the following:
o
Unlock and remove the bezel ("Front bezel" on page 32).
o
Extend the server from the rack (on page 30).
3.
Remove the access panel ("Access panel" on page 33).
4.
Disconnect the cable from the cache module only if the battery pack is not being used to recover
data from the server or transfer data to another server.