Filter
Top Products
Removal and replacement procedures 44
7.
Remove the expansion board.
CAUTION: Make a note of board locations. Be sure to install replacements in the same slots.
To replace the component, reverse the removal procedure.
Slot release lever
To remove the component:
1.
Power down the server (on page 31).
2.
Extend the server from the rack, if applicable ("Extend the server from the rack" on page 30).
3.
Remove the access panel ("Access panel" on page 33).
4.
Remove the expansion slot cover ("Expansion slot cover" on page 42).
5.
Remove any expansion board installed in the slot ("Expansion board" on page 43).
6.
From the rear of the chassis, push up on the lever locking tab.
7.
Pull the release lever forward to disengage the rear tabs from the chassis wall.