Filter
Top Products
Removal and replacement procedures 49
4.
Press the HP Systems Insight Display ejector button to extend the HP Systems Insight Display.
5.
Disconnect the Systems Insight Display cable from the system board ("System board components" on
page 84).
6.
Remove two T-10 screws on the side of the Systems Insight Display.
7.
Remove the Systems Insight Display.
To replace the component, reverse the removal procedure.
Memory boards and FBDIMMs
The server utilizes two memory boards. Each memory board consists of eight slots, numbered sequentially.
The paired banks are identified by the letters A through D. Each memory board supports 2x1 interleaving.
For maximum performance, HP recommends that both memory boards be populated with the same total
amount of memory to support 4x1 interleaving across both memory branches.
Observe the following warnings when performing a replacement procedure: