Filter
Top Products
Removal and replacement procedures 40
NOTE: The center wall is removed for illustration purposes only.
7.
Disconnect the SAS-SATA cables from the SAS backplane.
IMPORTANT: When installing a x3/x1 SAS cable, HP recommends that the x3 part of the
x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds to hard
drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard drive slots
2 to 4 will be connected, one continuous volume can be created.
8.
Remove the four screws that secure the drive cage to the chassis.