Filter
Top Products
Removal and replacement procedures 47
3.
Remove the media blanks.
NOTE: HP recommends that you remove all media blanks to facilitate drive installation.
Retain the blanks for future use.
To replace the component, reverse the removal procedure.
Half-height or full-height media devices
To remove the component:
1.
Power down the server (on page 31).
2.
Do one of the following:
o
Unlock and remove the bezel ("Front bezel" on page 32).
o
Extend the server from the rack (on page 30).
3.
Remove the access panel ("Access panel" on page 33).