Honeywell VM1 Laptop User Manual


 
5 - 16
The devices are paired. The Bluetooth bar code reader responds with a series of beeps and LED flashes.
Note: After scanning the Thor VM1 Bluetooth label, if there is no beep and no LED flash from the Bluetooth
bar code reader, the devices are currently paired.
See Bluetooth Beep and LED Indications (page 5-16).
Bluetooth Beep and LED Indications
Upon startup, if the Bluetooth device sounds a long tone, this means the Bluetooth device has not passed its
automatic Selftest and has entered isolation mode. If the Bluetooth device is reset, the sequence is repeated.
Contact Technical Assistance (page 9-1) for assistance.
Bluetooth Printer Setup
The Bluetooth managed device should be as close as possible, in direct line of sight, with the Thor VM1
during the pairing process.
1. Open the Bluetooth EZPair Panel.
2. Tap Discover. Locate the Bluetooth printer in the Discovery panel.
3. Tap and hold the stylus (or double-tap) on the Bluetooth printer ID until the right-mouse-click menu
appears.
Select Pair as Printer to pair the Thor VM1 with the Bluetooth managed printer.
The devices are paired. The Bluetooth managed printer may respond with a series of beeps or LED flashes.
Please refer to the Bluetooth managed printer manufacturer’s User Guide; it may be available on the manu-
facturer’s web site. Contact Technical Assistance (page 9-1) for Bluetooth product assistance.
Note: If there is no beep or no LED flash from the Bluetooth managed printer, the Thor VM1 and the printer
are currently paired.
Easy Pairing and Auto-Reconnect
The Bluetooth module can establish relationships with new devices after the user taps the Discover button. It can
auto-reconnect to devices previously known but which have gone out of range and then returned within range (up
to 32.8 ft (10 meters) Line of Sight).
Note: Configuration elements are persistent and stored in the registry.
Setup the Bluetooth module to establish how the user is notified by easy pairing and auto-reconnect events.
Beep Type from Bluetooth Device Behavior
Acknowledge label 1 beep
Label rejected 2 beeps at low frequency
Transmission error Beep will sound high-low-high-low
Link successful Beep will sound low-medium-high
Link unsuccessful Beep will sound high-low-high-low
LED on Bluetooth Device Behavior
Yellow LED blinks at 2 Hz Linking in progress
Off Disconnected or unlinked
Yellow LED blinks at 50 Hz Bluetooth transmission in progress
Yellow LED blinks at the same rate as the paging beep (1 Hz) Paging
Green LED blinks once a second Disabled indication