Filter
Top Products
4 - 48
1. Seat the D9 connector firmly over the USB Connector on the Quick Mount Smart Dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connector provides a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM1 with Strain Relief Cable Clamps (page 4-27).
Connect USB Client
Note: USB client connection is not used on Thor VM1 with a Windows Embedded Standard operating system.
Connect Serial Device
Note: Pin 9 of the COM port is configured to provide +5V.
See COM1 and COM2 Connector (page 8-4) for connector pinouts.
1. Seat the cable end connector firmly over the serial COM port on the Quick Mount Smart Dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM1 with Strain Relief Cable Clamps (page 4-27).
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the Quick Mount Smart Dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM1 is powered on, it provides power to the serial scanner.
4. Configure the Data Collection (DC) Wedge to manipulate scanned data as desired.
D9 Connector
USB Host Connector
USB Client Connector