Filter
Top Products
4 - 15
4
Vehicle Mounting and Accessory Installation
Introduction
The Thor VM1 is designed to be mounted to a Quick Mount Smart Dock in a vehicle with either a RAM mount or U Bracket sys-
tem. A power cable is provided with the Thor VM1 dock. Optional communication cables are available.
Vehicle mounting brackets are specifically designed for vehicle mount applications. The vehicle mounted assembly restrains the
Thor VM1 and isolates it from shock and vibration. A RAM metal table stand is available to secure the Thor VM1 and dock when
in an office environment, for example.
The vehicle mount holds the Quick Mount Smart Dock and the Thor VM1 attaches to the dock. The dock remains attached to
the vehicle, however, the Thor VM1 has a quick release located on the lower rear side that allows the Thor VM1 to easily be
removed from the dock. The Thor VM1 can be operated for a minimum of 30 minutes from an internal UPS battery when not
attached to a dock. The Thor VM1 can be transferred from one dock equipped vehicle to another for easy portability. The dock
provides accessory attachment and conditioned power for the Thor VM1.
Overhead, dash and roof support pillar mounting is via a RAM Mount or U-bracket accessory which includes all the hardware
required for vehicle mounting.
Never put the Thor VM1 into the vehicle mounted assembly until the assembly is securely fastened to the vehicle.
Prepare for Vehicle Mounting
The Thor VM1 should be secured to an area in the vehicle where it:
• Does not obstruct the driver's vision or safe vehicle operation.
• Will be protected from rain or inclement weather.
• Will be protected from extremely high concentrations of dust or wind-blown debris.
• Can be easily accessed by a user seated in the driver's seat while the vehicle is not in operation.
Quick Start
The following list outlines, in a general way, the process to follow when mounting the Thor VM1 in a vehicle. Refer to the fol-
lowing sections in this document for more details.
1. Install RAM Mount (page 4-18) or Install U Bracket Mount (page 4-24) to the vehicle.
2. Place Thor VM1 in the Dock (page 4-16).
3. Adjust the Thor VM1 to the best viewing angle.
4. Install Remote Antenna (page 4-51) if necessary.
5. Connect Cables (page 4-27) for any peripherals.
6. Connect vehicle power:
• 12-48 VDC Vehicles (10-60 VDC Direct Connection) (page 4-29)
• 60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Top of Lid) (page 4-38)
• 60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Side of Lid) (page 4-34).
• Thor VX8 / Thor VX9 Adapter Cable (page 4-43)
• VX6 / VX7 Adapter Cable (page 4-42)
7. Secure all cables in Strain Relief Cable Clamps (page 4-27).
The Thor VM1 is ready for use.
Maintenance - Vehicle Mounted Devices
Check the vehicle mounting hardware frequently and re-tighten if necessary.
If the vehicle mounting hardware and connections become broken, loose or cracked, the assembly must be taken out of service
and replaced. Contact Technical Assistance (page 9-1) for help.