Filter
Top Products
Notes:
a. Removing the rack doors and side panels might make your Rack PDU
installation easier.
b. Use clip nuts for rack cabinets with round holes; use cage nuts for rack
cabinets with square holes.
Cage
nuts
Cage
nuts
Clip
nuts
2. Verify that the circuit breaker switch is in the Off position before installing your
Rack PDU.
3. Install the horizontal mounting bracket 3on one side of the Rack PDU 5 with
M3x5 screws 4.
Note: There are two sets of mounting holes on the bracket. You can align the
Rack PDU to be even with the back of the rack cabinet or recessed
inside, depending on how you install the bracket.
4. Install the single-device attachment bracket 1 on the other side of the Rack
PDU 5 with two M3x5 screws 2. Make sure that you use the same set of
mounting holes on this bracket as you used on the bracket in the previous step.
5. Determine the U level within your rack cabinet where you are going to install the
Rack PDU; then, install the Flat Panel Monitor Rack Mount Kit and bracket
assembly 2 in the rear of the rack cabinet with four M6 screws and clip nuts
or cage nuts (two screws and nuts per bracket).
Figure 46. Installing the mounting brackets for a single device
134 Hardware Maintenance Manual: IBM PC Server/Enterprise Racks Types 9306, 9308