Filter
Top Products
8. Connect the power supply to the monitor and route the cable under the tab
near the top of the monitor stand 1; then, secure the power cable with the
cable clamp you removed from the original stand and coil excess cable inside
the monitor stand.
9. Connect the monitor signal cable to the monitor and route it under the tab in
the bottom of the monitor stand 2 and out the back of the stand through the
hole provided.
10. Replace the monitor stand cover 1.
11. Snap the new hinge cover 2 into place over the hinge assembly.
Note: Be sure to use the new hinge cover that comes with the Flat Panel
Monitor Rack Mount Kit because it has deeper grooves to
accommodate the new hinge assembly.
New hinge cover Old hinge cover
12. Snap the cable cover 3 into place on the back of the flat panel monitor.
Figure 85. Storing the power supply and routing cables
Figure 86. Installing the cable cover, hinge cover, and stand cover
180 Hardware Maintenance Manual: IBM PC Server/Enterprise Racks Types 9306, 9308