Filter
Top Products
Note: You do not need to remove the rear filler panels unless you are attaching the
rack cabinets to form a suite of rack cabinets.
Removing and installing side panels: Use the following procedure to remove
the NetBAY42 side panels:
1. From the inside rear of the rack cabinet, slide the side panel locking bar into the
unlocked position; then, slide the front side panel locking bar into the unlocked
position.
2. Tilt the bottom of the side panel slightly toward you; then, lift the side panel
away from the tabs on the top of the rack cabinet.
3. Repeat this procedure to remove both side panels.
Reverse this procedure to install the side panels. Slide both locking bars into the
locked position to secure the side panel to the rack cabinet.
Side panel
Rear locking bar
Front
locking
bar
Figure 10. Removing the NetBAY42 side panels
14 Hardware Maintenance Manual: IBM PC Server/Enterprise Racks Types 9306, 9308