Filter
Top Products
Table 18. PLINE MACRO to JES2 Parameter Mapping
PLINE
Parameter
Description JES2 LINE
Parameter
Comment
ADDR= Unit address of the BSC
emulator port or CTC adapter
UNIT= ″SNA″ or unit address
(4-digit addresses
supported)
CODE EBCDIC is the only value
allowed. (ASCII is not supported)
LINECCHR= EBCDIC or USASCII
supported
INTRPT Selector channel mode N/A Option not in JES2
MODSET BSC (2701) Adaptor
characteristics
INTERFACE=
CODE=
BSC adapter interface &
code
PSWRD Line password PASSWORD= BSC or dedicated SNA line
SWITCH Switched line or leased N/A Don′t specify LINE= on RMT
statement for switched lines
TIMEOUT Number of idle minutes before
forced off
(not on LINE
parm)
Specify DISCINTV= on the
RMT(nnnn) statement.
TRNSP Transparency feature TRANSPAR= Text transparency required
for NJE
10.4.1.3 Define BSC Remotes
This table shows the conversion of POWER PRMT parameters to JES2 RMT
remotes.
Table 19 (Page 1 of 2). PRMT MACRO to JES2 Parameter Mapping
PRMT
Parameter
Description JES2 RMT
Parameter
Comment
REMOTE remote ID number RMT(nnn) ′nnn′ is the remote ID
number
TYPE 2770, 2780, 3741, or 3780 for
BSC
TYPE 2770, 2780, or 3780/3781 for
BSC (3741 not supported)
ABE Additional buffer expansion
on 2770 and 3741
BUFEXPAN=2 (3741 not supported)
BE Buffer expansion on 2770 BUFEXPAN=1
CS Component selection TYPE=3781
or 2770
CSALST Component select for LST
output
N/A Not specified at this level -
based on device type (2770,
3781)
CSAMSG Component selection for
messages sent to remote
N/A Use MSGPRT=Y to route
messages to a printer
CSAPUN Component select for punch
output.
N/A Not specified at this level -
based on device type (2770,
3781)
HFC Horizontal Tabs HTABS
LIST Number of characters in
print line
N/A (not nec.)
LSTROUT Default print routing ROUTECDE Same for LST and PUN
MRF 2780 multi-record feature MRF2780
MSG width of message lines N/A (not nec.)
MSEEJCT Suppress skip-to-1 after
output before messages
N/A
228 VSE to OS/390 Migration Workbook