Filter
Top Products
10.4.3.3 Control Commands
Note: There is no equivalent function in JES2. See 10.1.1.4, “Printer Forms
Alignment via PSETUP” on page 208.
Table 26. Control Commands
POWER
Command
Code
PWR
Short
Form
Function JES2
Command
Verb
PACCOUNT J Save account file records. (SMF)
PBRDCST B Transmit a message. $DM, $M
PINQUIRE I Display the status of a BSC line, SNA logical unit,
or a node.
$D U,...
$D Node
PLOAD Load a network definition table. $T Node
PRESET Reset active jobs in a shared spooling
environment.
$E
PSETUP U Print a page layout. (see
Note)
PXMIT X Route commands to another node. $G $N
10.4.3.4 NJE Operator Commands
This section is a summary of NJE operator commands.
Network Management
The following tables provide a general reference of the operator commands
available on the various systems. Because of fundamental differences between
the systems, commands in the same row may not be identical. Refer to the
specific product operations guides listed above for details.
Table 27 (Page 1 of 2). Network Management Commands
Function POWER JES2
Start Lines N/A $SLNEnnn
Start Networking (BSC) S PNET,node,,line $SN,N=node
Enable VTAM ACB N/A $SLGNn
Start Networking (SNA) S PNET,node $SN,N=node
Start Transmitters PACT PNET,node,TRn $SLn.JTm,Ln.STm
Start Receivers PACT PNET,node,RVn $SLn.JRm,Ln.SRm
Drain Transmitters N PNET,node,TRn $PLn.JTm,Ln.STm
Drain Receivers N PNET,node,RVn $PLn.JRm,Ln.SRm
Drain Lines N/A $PLNEnnn
Stop Lines Immediately N/A $ELNEnnn
Cancel Line Activity F PNET,node $CLNEnn
Reset Lines N/A $ELNEn,LNEm,...
Stop Networking PPNET,node,EOJ $PLNEn,LNEm,...
Stop Networking
Immediately
PPNET,node $ELNEn,LNEm,...
Chapter 10. POWER and JES2 233