Filter
Top Products
•
p,m,Y2x: Must be removed. DFSORT terminates if this operand is specified.
p,m,Y2x can be specified in the OUTREC operand of DFSORT′s OUTFIL
statement.
•
p,m,PZ: Must be removed. DFSORT terminates if this operand is specified.
p,m,PZ can be replaced by p,m,PD0,M11 in the OUTREC operand of
DFSORT′s OUTFIL statement.
•
p,m,PSI: Must be removed. DFSORT terminates if this operand is specified.
p,m,PSI can be replaced by p,m,PD,M11 in the OUTREC operand of
DFSORT′s OUTFIL statement.
•
p,m,ZSI: Must be removed. DFSORT terminates if this operand is specified.
p,m,ZSI can be replaced by p,m,ZD,M11 in the OUTREC operand of
DFSORT′s OUTFIL statement.
19.3.2 ICETOOL
DFSORT/VSE′s ICETOOL and DFSORT′s ICETOOL were designed to be
functionally and syntactically compatible. However, differences between the VSE
and OS/390 operating systems require the following changes when migrating:
•
JCL Statements: The VSE JCL statements describing the files used by
ICETOOL must be changed to DD statements as described in the
DFSORT
Application Programming Guide
, SC33-4035.
•
DEFINE operator: Must be removed. ICETOOL terminates if this operator is
specified. ICETOOL obtains information about each input data set from the
DD statement, data set control block (DSCB) or catalog.
•
FROM operand: Each FROM operand that specifies more than one filename
must be changed to specify one ddname that identifies the input data sets
using concatenation.
•
LIST operand: Each LIST operand must be changed to specify a ddname that
identifies the list data set.
•
USE operand: Each USE operand must be replaced by a USING(xxxx)
operand where xxxx is a unique four-character identifier. The control
statements between (but not including) the USTART and UEND statements
must be placed in a data set defined by an appropriate xxxxCNTL DD
statement.
380 VSE to OS/390 Migration Workbook