Filter
Top Products
4. If you are installing drives in bank D for the first time, you must install a back-
plane in bank D before you can install drives. Contact your hardware support
center to install the backplane.
5. It is recommended that you install the hot-swap disk drive in the next unused
position of bank C or D, going from bottom to top.
Attention: Attaching SCSI address jumpers on the hot- swap disk drive rather
than using the automatic ID furnished by the backplane is not advised. Attaching
jumpers can cause service problems, multiple drives at the same address, or
confusion locating the correct drive.
a. Rotate the carrier latch to the open position.
SCSI Disk Drives
SSA Disk Drives
b. Position the drive carrier assembly horizontally, with the connector facing into
the bay.
Locked Position
Power
Ready
Check
5-8 RS/6000 Enterprise Server Model H Series User's Guide