Filter
Top Products
Emergency Eject
Note: Execute the following procedure only in an emergency (tray will not eject
although pressing the unload button).
1. Insert a small diameter rod, such as a straightened paper clip, into the emer-
gency eject hole. (Refer to the illustration below for the location of the emergency
eject hole.)
2. Push the tool in until you feel resistance.
3. Maintain a small amount of pressure on the rod while pulling on the tray with
your fingernail.
4. Pull the tray open and remove the disc.
Tray Opening
Emergency
Eject Access
Load/Unload
Button
Status LightVolume Control
Head Phone
Jack
Note: Normally the tray makes a ratcheting sound when pulling it open using the
above procedure.
Chapter 2. Using the System Unit 2-15