Filter
Top Products
Step 12
Did the Diagnostic Selection Menu display?
NO If Problem Determination was selected from the Diagnostic Mode
Selection menu, and if a recent error has been logged in the error log, the
diagnostics automatically begin testing the resource.
Follow the displayed instructions.
If the No Trouble Found screen is displayed, press Enter.
If another resource is tested, repeat this step.
If the Diagnostic Selection menu is displayed, go to “Step 13.”
If an SRN is displayed, record it, and go to “Step 14.”
YES Go to “Step 13.”
Step 13
The All Resources option checks most of the configured adapters and devices.
Notes:
1. ISA adapters cannot be detected by the system. The ISA adapter Configuration
Service Aid allows the identification and configuration of ISA adapters for
Standalone Diagnostics. ISA adapters must be identified and configured before
they can be tested.
Select and run the diagnostic tests on the resources you are having problems with or
select the All Resources option check all of the configured resources. Find the
response in the following table and take the Action for it.
Diagnostic Response Action
An SRN is displayed. Go to “Step 14.”
The system hangs. Report SRN 109-200.
The Testing Complete menu and the No trouble
was found message is displayed, and you have
not tested all of the resources.
Press Enter and continue with the testing.
The Testing Complete menu and the No trouble
was found message displayed and you have
tested all of the resources.
Go to “Step 17.”
Chapter 9. Hardware Problem Determination 9-7