Filter
Top Products
172 Building a Network Access Control Solution with IBM Tivoli and Cisco Systems
NO_KEY_RULE Operational Used to determine the status of the registry key existence
check if the registry key specified in KEY is not found. No
more than one parameter value should be provided. If
more than one parameter value is provided, only the first
parameter value will be used. The parameter value
provided should be one of the following: PASS, WARN, or
FAIL. If the parameter value is set to either WARN or
FAIL, then the KEY_WF workflow is used. The
required_values attribute of the workflow will be set to the
parameter value of the KEY parameter. If the parameter
value is set to something other than PASS, WARN or
FAIL errors may occur.
VALUE Operational Used to specify which registry value of the key indicated
by the KEY parameter should be evaluated. No more
than one parameter value should be specified. If a
parameter is provided it will be used for the registry value
existence check. If no parameter value is provided, the
only check run is the registry key existence check for the
key specified in the KEY parameter. If more than one
parameter value is provided, only the first parameter
value will be used.
NO_VALUE_RULE Operational Used to determine the status of the registry value
existence check if the registry key specified in the KEY
parameter is found, but the registry value specified in the
VALUE parameter is not. No more than one parameter
value should be provided, in which case only the first
parameter value will be used. The parameter value
provided should be one of the following: PASS, WARN, or
FAIL. If the parameter value is set to either WARN or
FAIL, then the VALUE_WF workflow is used. The
required_values attribute of the workflow will be set to the
parameter value of the VALUE parameter. The workflow
will also have the attribute key set to the parameter value
of the KEY parameter. If no parameter value is provided
and the registry value specified by the VALUE parameter
does not exist for the key specified by the KEY parameter,
then the parameter value of the DEFAULT_RULE
parameter is used. If the DEFAULT_RULE parameter is
not set, the registry value existence check defaults to
PASS.
Parameter name Parameter type Description