Filter
Top Products
Chapter 5 Using the Command-Line Interface 71
Configuring Secure Socket Layer (SSL) port
You can view and specify the ports to which SSL is restricted.
▼ Viewing SSL ports
1 Select the config menu, and press Enter.
2 Select protocols, and press Enter.
3 Select ssl, and press Enter.
4 Select view, and press Enter. Doing so displays the ports to which SSL is
restricted.
▼ Restricting SSL to specific ports
1 Select the config menu, and press Enter.
2 Select protocols, and press Enter.
3 Select ssl, and press Enter.
4 Select port, and press Enter. Doing so displays the current ports to which
SSL is restricted and a field in which you can specify additional ports.
5 Supply the ports to which SSL will be restricted, and press Enter. You can
enter a maximum of two ports. When entering more than one port,
separate them with blank space. Also, you must enter the complete list of
ports even if one is already specified in the existing list.
6 Press CTRL-X to save your changes and return to the previous screen.
Configuring FTP options
You can view the current FTP configuration settings, set the connection mode,
the inactivity timeout value, and the anonymous password.
▼ Configuring the FTP options
1 Select the config menu, and press Enter.
2 Select protocols, and press Enter.
3 Select ftp, and press Enter.
4 Select the configuration option you want to use, and press Enter:
✔ To view the current FTP configuration settings, select view, and press
Enter. The configuration settings display on screen.
✔ To set the connection mode, select mode, and press Enter. You can
select from three modes: PASV/PORT, PASV only, and PORT only.
Pressing Enter makes the selection.