21
2 Removing/Installing Server Components
This chapter provides procedures for removing and installing replaceable and/or upgradable
components in the Intel ISP1100 Internet Server. Before performing the procedures, be sure to
familiarize yourself with the following “Before You Begin” information.
Before You Begin
FCC/Emissions Disclaimer
This equipment has been tested and verified to comply with Class B limits when configured into a
compatible host computer, pursuant to Part 15 of the FCC Rules, CISPR 22, and EN55022. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
To ensure EMC compliance with your local regional rules and regulations, the final configuration
of your end system product may require additional EMC compliance testing. For more information
please contact your supplier
.
Warnings and Cautions
Read and adhere to all warnings, cautions, and notes in this guide and the documentation referenced
and supplied with the server. If the additional instructions supplied with the server are inconsistent
with these instructions, contact the supplier to find out how you can ensure that your server meets
safety and regulatory requirements.