Intel ISP1100 Server User Manual


 
44 Intel ISP1100 Internet Server Product Guide
Installing PCI Add-in Card(s)
This procedure describes how to install the PCI add-in card(s) in the server expansion slots. The
vertically mounted riser card accommodates one standard (left side) and one low-profile (right side)
PCI add-in card. Before proceeding, be sure you are thoroughly familiar with the information in
“Before You Begin” at the front of this chapter.
NOTE
If applicable, check that the add-in card jumpers or switches are set
according to the manufacturer’s instructions before proceeding.
Removing the Riser Card
Perform this procedure to remove the riser card from the server board. Refer to Figure 24 while
performing this procedure.
NOTE
This procedure assumes that the PCI add-in cards have been removed from
the server chassis as described in the previous “Removing the PCI Add-in
Card(s)” procedure.
1. Grasp the riser card at each end (A) and gently rock and lift the riser card until it releases from
the server board connector (B).
2. Remove the riser card from the server board.
B
A
OMO9437
Figure 24. Removing the Riser Card