Filter
Top Products
Removing/Installing Server Components 37
Removing the 3.5-inch Diskette Drive
This procedure describes how to remove the 3.5-inch diskette drive from the server drive bay.
Before proceeding, be sure you are thoroughly familiar with the information in “Before You Begin”
at the front of this chapter. Refer to Figure 17 while performing this procedure.
1. Disconnect the power and data cables (A) from the back of the drive.
2. Use a Phillips screwdriver and remove the three screws (B) that secure the mounting bracket
(C) and drive to the server chassis (two on one side and one on the other).
3. Remove the drive mounting bracket and drive.
4. Use a Phillips screwdriver and remove the four screws (D) that secure the mounting bracket to
the drive (two on each side).
5. Lift the drive from the mounting bracket.
OMO9455
A
B
C
D
D
Figure 17. Removing the 3.5-inch Diskette Drive