Filter
Top Products
Removing/Installing Server Components 39
Installing the 3.5-inch Diskette Drive in the Drive Bay
Perform this procedure to install the mounting bracket and drive in the server drive bay. Refer to
Figure 19 while performing this procedure.
1. Connect the power and data cables (C) to the drive. The red stripe (D) on the data cable
faces toward the center of the drive.
2. Place the mounting bracket and drive in the server chassis and align the three screw holes (A)
in the mounting bracket (two on one side and one on the other) with the mating holes in the
server chassis.
3. Use a Phillips screwdriver and the three screws (B) removed from the mounting bracket in the
preceding “Removing the 3.5-inch Diskette Drive” procedure to securely attach the mounting
bracket and drive to the server chassis.
OMO9457
C
D
B
A
Figure 19. Installing the 3.5-inch Diskette Drive in the Drive Bay