Intel ISP1100 Server User Manual


 
Removing/Installing Server Components 29
Removing the Processor Fan (If Applicable)
This procedure describes how to remove the processor fan from a replacement processor. Due to
space constraints, the server will not accommodate a processor with a fan mounted on the heat sink.
Sufficient cooling is provided in the server without the processor fan.
If the processor you wish to install has a fan mounted on top of the heat sink, remove the fan as
described in the following procedure. Otherwise, proceed to “Installing the Processor Chip.” Refer
to Figure 9 while performing this procedure.
1. Grasp the fan housing at each corner.
2. Gently press and lift on the corners until the fan releases from the heat sink.
OMO9430
Figure 9. Removing the Processor Fan