Intel ISP1100 Server User Manual


 
Removing/Installing Server Components 27
Removing the Processor
This procedure describes how to remove the processor on the server board. Before proceeding, be
sure you are thoroughly familiar with the information in “Before You Begin” at the front of this
chapter.
WARNING
If the server has been running recently, the processor chip, heat sink,
and adjacent components will be hot. To avoid burns, allow time for the
processor chip, heat sink, and adjacent components to cool before you
proceed with these procedures.
Removing the Processor Heat Sink
Perform this procedure to remove the heat sink from the processor. Refer to Figure 7 while
performing this procedure.
1. Use a slotted screwdriver and insert the tip into the top slot in the end of the heat sink clamp
(A) that has two slots.
2. Press down on the top of the clamp (B) while gently prying back on the screwdriver until the
front of the clamp is loose from the tab (C) on the processor socket.
3. Grasp the front and back of the clamp and gently lift the front of the heat sink until the rear of
the clamp releases from the tab on the processor socket.
4. Remove the clamp.
5. Lift the heat sink from the processor chip.
A
B
C
OMO9450
Figure 7. Removing the Processor Heat Sink