Intel ISP1100 Server User Manual


 
26 Intel ISP1100 Internet Server Product Guide
Removing the Cover
This procedure describes how to remove the cover from the server. Before proceeding, be sure you
are thoroughly familiar with the information in “Before You Begin” at the front of this chapter.
Refer to Figure 6 while performing this procedure.
1. Use a Phillips screwdriver and remove the screw (A) from the front edge of the cover.
2. Grasp the back edge of the cover and simultaneously pull from the back edge and push near the
front until the cover slides out from under the edge of the server front panel.
3. Grasp the notch (B) in the front center of the cover and lift to remove the cover.
Replacing the Cover
This procedure describes how to replace the cover on the server. Before proceeding, be sure you
are thoroughly familiar with the information in “Before You Begin” at the front of this chapter.
Refer to Figure 6 while performing this procedure.
1. Position the cover on the chassis with the notched edge (B) facing the front and the slotted sides
of the cover inside the chassis frame.
2. Grasp the back edge of the cover and simultaneously push from the back and top until the front
edge of the cover slides all the way under the edge of the server front panel.
3. Use a Phillips screwdriver and the screw (A) removed in the previous “Removing the Cover”
procedure to securely attach the cover to the chassis.
A
B
OMO9449
Figure 6. Removing/Replacing the Cover