Intel ISP1100 Server User Manual


 
22 Intel ISP1100 Internet Server Product Guide
WARNINGS
This chapter is intended for qualified technical personnel with
experience installing and configuring servers.
SYSTEM POWER ON/OFF: The Power button on the server front
panel DOES NOT remove AC power to the server system. Some
circuitry in the server may continue to operate even though the front
panel Power button is off. Always disconnect the power cord from the
AC power source or wall outlet before performing any of the procedures
in this guide. Failure to do so can result in personal injury or equipment
damage.
HAZARDOUS CONDITIONS, POWER SUPPLY: Hazardous voltage,
current, and energy levels are present inside the power supply. There
are no user-serviceable parts inside the power supply; servicing should
be done by technically qualified personnel.
HAZARDOUS CONDITIONS, DEVICES, AND CABLES: Hazardous
electrical conditions may be present on power, telephone, and
communication cables. Press the Power button to turn off the server
and disconnect the power cord from the AC power source,
telecommunications systems, networks, and modems attached to the
server before removing the cover. Otherwise, personal injury or
equipment damage can result.
CAUTIONS
ELECTROSTATIC DISCHARGE (ESD) AND ESD PROTECTION:
Perform the procedures in this chapter only at an electrostatic discharge
(ESD) workstation since the server components can be extremely sensitive to
ESD. If no such station is available, you can reduce the risk of electrostatic
discharge ESD damage by doing the following:
Wear an antistatic wrist strap and attach it to a metal part of the server.
Touch the metal on the server chassis before touching the server components.
Keep part of your body in contact with the metal server chassis to dissipate the static
charge while handling the components.
Avoid moving around unnecessarily.
Hold the server components (especially boards) only by the edges.
Place the server components on a grounded, static-free surface. Use a conductive foam
pad if available but not the component wrapper.
Do not slide the components over any surface.
COOLING AND AIRFLOW: For proper cooling and airflow, always
install the chassis access cover before turning on the system. Operating the
system without the cover in place can cause overheating and damage to
system parts.