24 Intel ISP1100 Internet Server Product Guide
Safety and Regulatory Requirements
This product was evaluated for use in computer racks within computer rooms and similar locations.
Other uses require further evaluation.
Safety Compliance
USA/Canada
UL 1950, 3
rd
Edition/CSA 22.2, No. 950M93, 3
rd
Edition
Europe
Low Voltage Directive, 73/23/EEC
TUV/GS to EN60950 2nd Edition with Amendments, A1 = A2 + A3 + A4
International
CB Certificate and Report to IEC 60950, 3rd Edition including EMKO-TSE (74-
SEC) 207/94 and other national deviations
Electromagnetic Compatibility (EMC)
USA
FCC 47 CFR Parts 2 and 15, Verified Class A Limit
Canada
IC ICES-003 Class A Limit
Europe
EMC Directive, 89/336/EEC
EN55022, Class A Limit, Radiated & Conducted Emissions
EN55024, Immunity Standard for Information Technology Equipment
EN61000-3-2 Harmonic Currents
EN61000-3-3 Voltage Flicker
Australia/New Zealand
AS/NZS 3548, Class A Limit
Japan
VCCI Class A ITE (CISPR 22, Class A Limit).
IEC 1000-3-2; Harmonic Currents
Taiwan
BSMI, Class A (CISPR 22)
Russia
Gost Approval
International
CISPR 22, Class A Limit
Tools and Supplies Needed
1. Phillips (cross-head) screwdriver (number 1 and 2 bit)
2. Flat-head screwdriver (3/16-inch)
3. Jumper removal tool or needle nosed pliers
4. Pen or pencil
5. Antistatic wrist strap and conductive foam pad (recommended)
Removing the Server From the Rack
This procedure describes how to remove the server from the rack. Before proceeding, be sure you
are thoroughly familiar with the information in “Before You Begin” at the front of this chapter.
Refer to Figure 5 while performing this procedure.
1. Use a Phillips screwdriver to remove the two screws (C) that secure the server mounting
brackets to the rack posts (B).
2. Carefully remove the server from the front of the rack.